casinilogic

Best Answer: Magnavox DVD player codes. 254 237 1.Turn on the equipment you wish to program. Classic Dungeon X2 English Patch.

How to activate or reset your digital set-top box CABLE IN. Your TV remote. Television Coax Cable Digital Set-Top Box. ©2013 Charter Communications Inc.

(TV, VCR, DVD or AUX) 2. Press the [SELECT] button and [MUTE] button simultaneously for 3 seconds. The device LED's blink in sequence (TV-VCR-AUX-CBL-TV) 3.Release the buttons when the desired device button is blinking (the device LED will then remain lit). 4.Point the remote control toward the equipment and enter the three-digit code. 5.Store the three-digit code number by pressing the [SELECT] button. The device LED will blink twice to confirm that the code has been stored.

• Tell us some more • Upload in Progress • Upload failed. Please upload a file larger than 100x100 pixels • We are experiencing some problems, please try again. • You can only upload files of type PNG, JPG, or JPEG. • You can only upload files of type 3GP, 3GPP, MP4, MOV, AVI, MPG, MPEG, or RM. • You can only upload photos smaller than 5 MB. • You can only upload videos smaller than 600MB. • You can only upload a photo (png, jpg, jpeg) or a video (3gp, 3gpp, mp4, mov, avi, mpg, mpeg, rm).

• You can only upload a photo or a video. • Video should be smaller than 600mb/5 minutes • Photo should be smaller than 5mb •.

A Charter remote control can be programmed to operate a number of devices, including a VCR, DVD player, audio receiver and television. The codes for these devices can usually be found in the owner's manual of the device. If the device code is known, begin by turning on that device. Then, on the remote control press the button that corresponds to the device. For example, if programming a DVD player, hit 'DVD.' After the button blinks once, press and hold the 'SETUP' button on the remote until the device button blinks twice. Once it blinks twice, the remote is ready to be programmed.

Release the 'SETUP' button and while pointing the remote control towards the device, enter the four-digit code. The device button should then blink twice.

Press the 'PWR' button on the remote, and if the code has been entered correctly, the device will shut off. If the device does not have a power button, use the 'PLAY' button on the remote instead. Codes for many devices can also be found online at urcsupport.com.